8
START UP MANUAL
HYDROBAR EXPRESS 326 S2
Note
:
Depending on
lathe
configuration,
there may be
other
parameters
available.
For further
information,
see chapter 8 /
point 5.
Example 2: Small-diameter profiled bars / standard elements in the front rest.
Bar profile
hexagonal
Bar diameter (acros adges)
6 mm
Guiding channel diameter
8 mm
Length of pieces to be machined
15.0 mm
Thickness of the cutoff tool
2.0 mm
Press the [
MENU
] key; the remote command displays the following text :
PARAMETERS RELATED TO START-UP
Press the [
ENTER
] key; the remote command displays the following text :
BAR STOCK DIAMETER :
On the keypad enter [6] (barstock diameter across edges)
Press the [
ENTER
] key twice, the remote command displays the following text :
GUIDING ELEMENTS DIAMETER
On the keypad enter [8]
Press the [
ENTER
] key twice, the remote command displays the following text :
INPUT OVERALL PART LENGTH
On the keypad, enter [17], which represents the sum of the bar length and the thickness of
the cutoff tool.
Press the [
ENTER
] key twice to store the data.
Press the [
ESC
] key to exit the set-up functions.
Press the key attributed to the icon
[PAGE DOWN]
.
The remote command displays the following text :
ADDITIONAL PARAMETERS RELATED TO START-UP
Press the [
ENTER
] key, the remote command displays the following text :
ROUND / PROFILED MATERIAL
Select [ROUND / PROFILED] then, to save, press [ENTER] twice.
As the guide elements have not been replaced, when this parameter is selected, the front rest
is adjusted as for round stock. In automatic mode, when the bar is guided by the front rest,
the motor (M3) adjusts the front-rest gap to the setting entered into the [BAR STOCK
DIAMETER]. Similarly, when the pusher is in the front rest, the motor (M3) adjusts the gap
according to the setting entered into the [GUIDING ELEMENTS DIAMETER] parameter.
However, the positioning cycle (Top Cut) cycle is adapted to load profiled stock.
Press the [
ESC
] key to exit the set-up functions.
Содержание 326 S2
Страница 1: ...ENG...