LNS 326 S2, Руководство для стартапов, Страница: 6 / 17

START UP MANUAL 5
HYDROBAR EXPRESS 326 S2
2.2 Top-cut position
During the loading cycle, the bar is
automatically loaded and positioned into
the spindle, outside the clamping device of
the lathe (chuck or actuator).
This positioning corresponds to a value (Z)
programmed by the operator, which is
equal to the distance between the
measuring cell and the position of the
material in the lathe clamping device.
With this system, the setting is the same for
any bar length.
The setting for the Top-cut position may be
adjusted at any time, in one of two ways :
1. Par correction de la valeur
2. Par apprentissage ( Teach In)
Top cut position setting :
Important : Before handling the barfeeder, stop the lathe at the end of part cycle.
1. Press the key
[STOP]
.
2. Press the key [MENU] .
The display reads :
PARAMETERS RELATED
TO START UP
3. Press twice the key attributed to the icon
[PAGE DOWN]
.
The display reads :
SETTINGS FOR
POSITIONING
4. Press the key attributed to the icon
[ENTER]
.
The display reads :
POSITION OF THE END OF THE
BAR **** MM