LNS 326 S2, Руководство для стартапов, Страница: 7 / 17

6 START UP MANUAL
HYDROBAR EXPRESS 326 S2
5. Press the key attributed to the icon
[PAGE DOWN]
.
The display reads :
POSITION OF THE CUT OFF
(TOP CUT) **** MM
6. Press the key attributed to the icon
[SET]
.
Depending on which sequence the bar feed is in when the parameter is selected, the
available functions and icons can change :
Functions
Conditions
By offset correction
By teaching
- Guiding channel closed
- No bar stock in the guiding channel
icon
: [+/-]
---
- Guiding channel closed
- Bar stock in the guiding channel
icon
: [+/-]
---
- Guiding channel open
- No bar stock in the guiding channel
icon : [+/-]
---
- Guiding channel open
- Bar stock in the guiding channel
- Movable vise in home position
icon : [+/-]
icon :
[TEACH IN]
[+/-] By offset correction
C
Press the key attributed to the icon [+/-] .
The display reads the current top cut position.
C
Enter the correction value with the numerical keys. Then, press the key attributed to
the icon
[+] to add the value, or the key attributed to the icon [-] to substract it. The
display reads the new top cut position.
C
To exit the top cut set mode, press the key attributed to the icon
[ESC].
[TEACH IN]
By teaching
C
Press the key attributed to the icon [TEACH IN] .
C
Press the key attributed to the icon [START] .
The movable vise closes and advances the bar stock against the front stopper. The
bar is thus measured. The movable vise continues its travel and positions the bar
inside the spindle of the lathe. The guiding channel closes. The feeding pusher is
now facing the bar. The movable vise moves back and positions the material inside
the collet of the bar feed system.
C
Press the key [FWD] and advance the bar stock to the desired position (see previous
page).
C
To validate the new top cut position, keep
[ENTER]
pressed until the icon
disappears
.
7. To exit the set mode, press the keys
[MENU]
or
[STOP] .