LNS 326 S2, Руководство для стартапов, Страница: 4 / 17

START UP MANUAL 3
HYDROBAR EXPRESS 326 S2
Note :
To validate a
new
parameter or
a new value,
keep
[ENTER]
pressed until
the icon
disappears
2. SETTINGS RELATED TO INSTALLATION
2.1 End of bar
The end of bar position determines the
moment when the bar feed enters the
loading cycle.
Usually, the end of bar position is adjusted
as closely as possible behind the clamping
system of the lathe (approximately 5 mm or
a 1/4" behind the chuck jaws or collet
pads).
This will provide minimum bar stock
remnant.
Regardless of the length of the bars, or
parts, the end of bar position is always the
same.
In very special cases, a different end of bar setting needs to be selected.
The length of the remnant may vary :
C
The minimum remnant length (Min) is
obtained when the feeding pusher is just
behind the clamping device while the
last part is being machined.
C
The maximum remnant length (Max) is
obtained when there is not enough
material for machining an additional
part (Lp - 1 mm).
Maximum remnant length =
Lp - 1mm + Min