LJ Star LumiStar 1000, Инструкция по установке и эксплуатации

Страница: 6 / 8

5.00 Operation
5.10 Continuous Mode – for Indicator-Equipped Luminaire
- When power is applied, the blue LED on the indicator will blink twice while the
processor initializes.
- The LED and luminaire will remain on while power is supplied and turn off when
power is removed. Control operation using external on/of power switch.
5.20 Button Operation – for Button-Equipped Luminaire
The below instructions apply to LED luminaires equipped with a button on the housing
and/or to LED luminaires equipped with an M12 connector cable connected to an
external switch.
- When power is applied, the blue LED on the switch will blink twice while the
processor initializes. The LED will then periodically flash to indicate power is
applied.
- One Button Press: 2-minute on time. Light shuts off after 2 minutes. Second press
turns off light.
- Two Rapid Presses: 30-minute on time. Light shuts off after 30 minutes. Additional
press turns off light.
- Three Rapid Presses: Light becomes dimmable. The light will dim 10% for every
button press. When the light reaches 10% output, indicated by a flash, each press will
increase the light output by 10%.
- Press and Hold: Switch becomes momentary. Light remains on until switch is
released.
6.00 Safety
- Do not look directly into light source – risk of eyesight damage.
- Use caution when touching housing body as heat is generated during operation.
Manual: 02-0158 - IOM
5
05/22