Press the SET key to confirm the value. Now the required therapy time is flashing.
It can be confirmed with the SET key.
Please note: Changing the therapy time with the „+/–“-key also changes the dose
needed for said therapy time depending on the selected output.
Possible settings for the therapy time are:
10 seconds to 1 minute in increments of 10 seconds
1 minute to 15 minutes in increments of 1 minute
Possible settings for the dose are:
1 J to max. 45 J
Once all laser parameters have been set, this is shown in the display. The
individual values are no longer flashing and you may start with the laser treat-
ment (● section 7.0 *Using the laser*, page 14ff).
Please note:
The maximum energy dose rate that can be selected is determined by the
maximum therapy time and the maximum laser power level of the laser shower
PowerTwin21.
Example
:
Maximum therapy time for the laser shower PowerTwin21 (50 mW)
is 15 minutes and maximum laser power is 50 mW. The maximum energy
dose rate that can be set is therefore 50 mW x 15 minutes x 60 s = 45 J/LD.
The minimum dose that can be selected is 1 J.
Note
:
Please note that since energy and therapy time are correlated, changing
either one of the two parameters will impact the other parameter.
The other value will be adjusted automatically.
The selected value for the therapy time is confirmed and stored by pressing the
SET key again. You can now start using the laser.
Please note that the settings for the parameters are retained when the unit is
turned off and on again.
page 13 of 29
