LIVARNO LUX 273745, Инструкция по сборке, эксплуатации и безопасности

Страница: 25 / 29

25 GB
winter, it should be cleaned and stored in a
dry, warm location.
The solar light is intended as an outdoor
accent light.
Safety instructions for
rechargeable batteries
RISK OF AC-
CIDENT AND DANGER TO LIFE
FOR INFANTS AND CHILDREN!
Rechargeable batteries are not intended to be
in the hands of children. Do not leave the bat-
teries lying around. They may otherwise be
swallowed by children or pets. If accidentally
swallowed seek immediate medical attention.
CAUTION! EXPLOSION HAZ-
ARD!
Use only rechargeable bat-
teries of the recommended type.
Other rechargeable or single-use batteries could
explode during charging.
FIRE HAZARD! Do not allow re-
chargeable batteries to short-circuit.
Otherwise the rechargeable batteries
may overheat, become a fire hazard or explode.
CAUTION! EXPLOSION HAZ-
ARD!
Never throw rechargeable
batteries into fire or water.
Outdated or used rechargeable batteries may
leak chemicals which damage the product.
Remove, therefore, the rechargeable battery when
the lamp is not required for any length of time.
WEAR PROTECTIVE GLOVES!
If they come into contact with skin,
leaked or damaged rechargeable
batteries could cause chemical burns; you should
therefore wear suitable protective gloves at all
times if such an event occurs.
Only use rechargeable batteries of the correct
size and and the recommended type (see
section ”Technical Data”).
Ensure correct polarity, indicated in the battery
compartment.
Functionality
The integrated solar cell of the article converts so-
lar radiation into electrical energy and stores it in
the Ni-MH rechargeable battery. Switches on the
light as it begins to get dark. The built-in LED is an
energy-saving illuminant with a very long life. The
light duration depends on the amount of sunlight,
the angle of light on the solar panel and the tem-
perature (the battery capacity is temperature-de-
pendent). A vertical angle of light at temperatures
above the freezing point is ideal. The rechargeable
battery will only achieve its maximum capacity
after several charging and discharging cycles.
Start-up
Mounting the light
Pull the solar cell housing
2
including lamp-
shade
1
out of the lamp body
3
.
Push the ground spike
4
out of the adapter
5
and into the lamp body
3
.
Push the ground spike
4
into the ground in the
desired location, then attach the lamp body
3
.
Turn the solar cell housing
2
out of the lamp-
shade
1
counter-clockwise.
Set the ON / OFF switch
7
to the “ON“ posi-
tion to allow the product to switch on in the dark.
Insert the solar cell housing
2
into the lamp-
shade
1
and tighten clockwise.
Attach the lampshade
1
to the lamp body
3
.
Your solar light is now ready for use.
Installing the light
Push the ground spike
4
far enough into the
ground (lawn, flower bed) so it is firmly posi-
tioned upright in the ground. Then attach the
assembled solar light to the ground spike
4
.
Make sure it is firmly positioned. Do not use
any force when assembling or setting up the
product, e.g. hammer blows. This will damage
the product. In order to achieve the best result,
set the solar garden lamp up in a place where