Little Giant WSV50HM, Руководство пользователя

Страница: 1 / 24

WSV50HM Effluent Pump
OWNER'S MANUAL
English
EN
This pump is intended for use in effluent or raw sewage applications where the
total head required (including pipe friction losses) does not exceed the pump's
maximum capability. Do not pump mud, cement, tar, abrasives, or chemicals. This
pump is equipped with a 2" NPT (51 mm) discharge.
This product is covered by a Limited Warranty for a period of 3 years from the
date of original purchase by the consumer. For complete warranty information,
refer to
www.LittleGiant.com .
Specifications
SAFETY INSTRUCTIONS
This equipment should be installed and serviced by technically qualified personnel who are familiar with
the correct selection and use of appropriate tools, equipment, and procedures. Failure to comply with
national and local electrical and plumbing codes and within Little Giant recommendations may result in
electrical shock or fire hazard, unsatisfactory performance, or equipment failure.
Know the product’s application, limitations, and potential hazards. Read and follow instructions carefully to
avoid injury and property damage. Do not disassemble or repair unit unless described in this manual.
Refer to product data plate(s) for additional precautions, operating instructions and specifications.
Failure to follow installation or operation procedures and all applicable codes may result in the following
hazards:
Model HP Volts Hz
Amps
Watts
Shut-Off
(ft/m)
FLA Start
WSV50HM 1/2 115 60 10.2 39 1100 45/13.7
Risk of death, personal injury, or property damage due to explosion,
fire, or electric shock.
• Do not use to pump flammable, combustible, or explosive fluids such as gasoline, fuel oil, kerosene, etc.
• Do not use in explosive atmospheres or hazardous locations as classified by the NEC, ANSI/NFPA70.
• Do not handle a pump or pump motor with wet hands or when standing on a wet or damp surface, or in water
until the unit is unplugged or electrically disconnected.
• When a pump is in its application, do not touch the motor, pipes, or water until the unit is unplugged or electri -
cally disconnected.
• If the power disconnect is out of sight, lock it in the open position and tag it to prevent unexpected application of
power.
• If the disconnect panel is not accessible, contact the electric company to stop service.