Parts Check List
3
11x Large Screws (35mm)
You will also need a screwdriver
16x Large Cam Pins
4x Small Cams (Drawer)
16x Large Cams
8x Small Screws (11mm)
4x Mounting Plates with screws
1x Allen Key
2x Rubber Buffers
Ends x2
Carcass Base x2
Side Rails x2
Mattress Base x1
Carcass Plinth x2
Carcass Back x2
Middle Brace x1
Shelf x1
Drawer Front x1
Drawer Sides x2
(Left & Right)
Doors x2
Drawer Base x1
Drawer Back x1
4x Drawer Castors
4x Hinges with screws
8x Bolts (15mm)
(Not supplied)
12x Dowels
Carcass Side x1
(Outside) Left Hand Side
Carcass Side x1
(inside) Left Hand Side
Carcass Side x1
(Outside) Right Hand Side
Carcass Side x1
(inside) Right Hand Side
4x Bolts (35mm)
4x Small Cam Pins (Drawer)
4x Euro Screws (15mm)
34x Large Screws (25mm)
4x Shelf Studs
4x Feet
Assembly
1. Preparing the carcass sides.
You need:
12x Cam Pins and a Screwdriver.
Place the Carcass Sides inside face up on a flat surface.
Insert 3x Cam Pins into the smaller holes in each side as shown below.
Repeat this assembly process for all four Carcass sides.
2. Attach the Carcass Base and Plinth to the sides.
You need:
12x large Cams, 4x Dowels and a Screwdriver.
Fit 2x Dowels into the ends of each Plinth. Align the Base and Plinth with the Sides and
engage the Cam Pins and Dowels. Flip the subassembly onto its back to make it easier to fit
the cams (shown below).
Insert 6x cams into the large holes on the bottom of each sub assembly, please ensure that
the arrow on the Cam is pointing towards the corresponding Cam Pin when inserted.
Once all is aligned and engaged, tighten the Cams clockwise with a screwdriver to secure the
structure. Repeat this assembly for the other side.
4
are pointing towards the Cam Pin
ensure arrows on Cams
When engaging,
Inner and Outer
left
hand Carcass Sides
Inner and Outer
Right
hand Carcass Sides
