8
Assembly
Do not fi t the shower into locations where you do
not have at least 40cm access all around the cabin
both for installation and for future service access.
We advise you do to fi t sinks, toilets etc that restrict
access behind the shower.
You must ensure you can slide the cabin away from
the wall/corner for service access.
Smooth and level walls and fl oor are required for
ideal installation conditions. Avoid carpet or vinyl
fl oors.
Please ensure you have correctly water tested the
tub before you continue.
NOTE: The base and roof will have a protective fi lm
that must be carefully removed before assembly.
Please inspect all parts carefully before
assembly.
BY COMMENCING ASSEMBLY OF THIS SHOWER
YOU ACCEPT THAT THE PARTS HAVE ALL BEEN
CHECKED AND ARE UNDAMAGED.
This product is fi tted
with
toughened safety
glass. The
glass is stronger than regular
glass and if it breaks it will form
small pieces
of cubed glass, not
dangerous shards of glass. These small
pieces are still sharp, so care must be
taken to
handle br
oken glass with care.
If the glass is put under stress or is chipped
it will break.
DO NOT ALLOW THE GLASS TO IMPACTED
HARD SURFACES OR OBJECTS AS
THIS MAY CHIP/WEAKEN THE GLASS.
WEAKENED GLASS THAT IS CHIPPED OR
UNDER TENSION MAY SHATTER AT ANY
TIME, NOT ALWAYS IMMEDIATELY.
REMOVE THE WHITE PLASTIC COVER ON THE
BACK OF THE TOWER PANEL
Fitted to the rear
of the tower panel
is a white plastic
protective cover.
This part is fi tted to
protect the valve
and pipes during
transport.
REMOVE and
DISPOSE of this part
as it is not needed.
