Lippert SlimRack, Руководство пользователя

Страница: 8 / 24

Rev: 01.07.22
Page 8
CCD-0001459
Fig. 11 Fig. 10
B
A
C D
A
Troubleshooting
Manual-Program Motorized and Towable Controllers
Controllers 1510000199 / 366697 , 700155, 700157 which connects to a touchpad, has the ability to detect
and display several faults. When a fault is detected, the slide-out room movement will stop and two different
LEDs on the touchpad will flash in a pattern.
NOTE:
The slide-out system with controller 1510000199 / 366697 , 700155, 700157 will
NOT
function until
the stops are properly set or faults are cleared.
1.
The FAULT CODE LED (Fig. 10A) on the touchpad will flash red a number of times corresponding to a
specific fault code. Refer to Fault Code Table - Controller 1510000199 / 366697 , 700155, 700157 to best
determine what caused the fault.
2.
The ROOM MOVEMENT LED (Fig. 10B) on the touchpad indicates system operation and will flash green
a number of times corresponding to which motor had the associated fault.
NOTE:
For example, four RED flashes (Fault Code) and two GREEN flashes (Motor code) means there is a
motor fault on Motor 2.
NOTE:
A solid GREEN LED indicates normal slide-out room movement.
There are two types of faults, minor and major. Faults
MUST
be cleared in order for the slide-out room to operate.
1. Minor faults can be cleared by pressing and releasing the IN (Fig. 10C) or OUT (Fig. 10D) buttons on the
wall touchpad.
2.
Major faults
MUST
be cleared by pressing and releasing the SET STOPS/CLEAR FAULTS button located
on the back of the touchpad (Fig. 11A).
NOTE:
For major faults, the controller must be overridden by following the Electrical Override Mode
procedure described in the Override Mode section. When the problem is repaired, the controller
must then be reprogrammed by an OEM-authorized dealer.
Preparation
Resources Required
• 1-2 people, depending on task • 3" extension for sockets
• Phillips head screwdriver •
5/8
" deep well socket
• Pick tool • 12V DC power source
• Ratchet or socket wrench • Multimeter
•
1/2
" 8-point star socket or 15 mm
12-point star socket
•
5/16
" open-ended wrench or ratcheting box wrench
• Dry lubricant