Lippert SlimRack, Руководство пользователя

Страница: 9 / 24

Rev: 01.07.22
Page 9
CCD-0001459
Fault Code Table - Programmable 1510000199 / 366697
Fault
Code
(# of RED
flashes)
Fault
Type
Description Why? What Should Be Done?
1 Major
Stops not
programmed
Stops have not been set
Stops must be programmed by an
authorized service facility.
Stops were cleared
Stops were improperly set
2 Minor System fault
Obstruction present
Run slide-out room in opposite direction of
drag. If slide-out room continues to move
in opposite direction, remove obstruction
or have damaged component replaced. If
slide-out room stops moving in opposite
direction, observe fault code and refer to
this chart.
Excessive system drag
Run slide-out room in opposite direction
of drag. If slide-out room continues to
move in opposite direction, remove
obstruction or have damaged component
replaced. If slide-out room stops moving
in opposite direction, observe fault code
and refer to this chart.
4 Major Motor fault
Bad or loose connection(s)
Check all connections at controller and
motor. See Wiring Diagram for Controller
1510000199 / 366697 , 700155, 700157.
Defective harness
Check harness for broken wires. Replace
as needed.
Open or shorted motor
Apply a 12V DC power source to the
motor. If motor does not operate, replace
the motor.
6 Minor
Excessive
battery voltage
Supply voltage to controller is
17V DC or greater
Use a multimeter to check 2-pin power
connector at controller. See Wiring
Diagram for Controller 1510000199 /
366697 , 700155, 700157. If the voltage is
17V DC or higher, contact OEM for power
and ground supplies.
Park brake LED flashing
Parking brake not set if
applicable
Set parking brake if applicable
Ground signal lost at
park brake connector
on controller
Check for continuity to ground on wire
plugged into park brake connector
at controller. See Wiring Diagram for
Controller 1510000199 / 366697 .
Low voltage LED flashing
Incoming voltage to controller
is below 12V DC
Use a multimeter to check 2-pin power
connector at controller. See Wiring
Diagram for Controller 1510000199 /
366697 . If the voltage is below 12V DC,
contact OEM for recommendation.