Rev: 11.27.19
Page 5
CCD-0002710
3.
Mark the locations of the drive-side (Fig. 3A) and idler-side (Fig. 3B) adjustment assemblies.
4.
Mark the location for an access opening on the unit's main floor to accommodate the placement of the
vertically mounted drive-side motor (Fig. 3C).
5.
Use a 1/2" drill bit to drill the eight mounting bracket through-holes located in step 2.
6.
Use a 1 3/8" drill bit to drill the two clearance holes for the adjustment assemblies located in step 3.
7.
Use a saw to cut the vertical motor's access opening located in step 4.
Fig. 3
8.
Set the drive-side motor assembly into its access opening and the adjustment assembly into its
clearance hole.
A.
Align the mounting bracket's through-holes with the drilled holes in the floor.
B.
Fasten the drive-side mounting bracket to the floor using OEM-supplied 3/8" - 1 1/2" bolts, 3/8"
SAE flat washers and 3/8" nylon locking nuts.
NOTE:
Maintain parallelism between dual slide arms. If applicable, for dual assemblies it is critical that the
assemblies be installed (timed) so that the slide-out room extends and retracts evenly.
9.
Set the idler-side adjustment assembly into its clearance hole.
A.
Align the mounting bracket's through-holes with the drilled holes in the floor.
B.
Fasten the idler-side mounting bracket to the floor using OEM-supplied 3/8" - 1 1/2" bolts, 3/8"
SAE flat washers and 3/8" nylon locking nuts.
NOTE:
Maintain parallelism between dual slide arms. If applicable, for dual assemblies it is critical that the
assemblies be installed (timed) so that the slide-out room extends and retracts evenly.
A
B
C