Rev: 11.27.19
Page 12
CCD-0002710
2.
At the motor end, use a 7/16" wrench to remove the 1/4" - 20 bolt (Fig. 10A) and nylon locking nut
(Fig. 10B) from the outer x-shaft (Fig. 10C).
NOTE:
This is the part that allows the follow slide to be adjusted, pulling the room closer to or further away
from the wall at the idler end.
Fig. 10
Syncing the Slide-Out
When the two opposing sides of the slide-out are misaligned—out-of-sync—an adjustment can be made to
realign—sync—the system by performing a manual adjustment of the outer x-shaft (Fig. 1).
Before accessing the power unit, make sure power to the system has been disconnected.
The slide-out adjustment for syncing the LCI Above Floor Slide-out is handled through the drive shaft (Fig.
1).
To sync the slide-out system, do as follows:
1.
Access the slide-out's drive-side rail assembly (motor end) (Figs. 1 and 3).
NOTE:
The slide-out shaft will be accessible from the inside of the unit. The slide-out motor and mechanism
are accessible from the outside.
Always disconnect battery from system prior to manually operating system. Failure to disconnect
battery can cause electricity to back feed through the motor and cause serious damage to the
system as well as voiding the warranty.
A
B
C
Motor End