Rev: 11.27.19
Page 11
CCD-0002710
Troubleshooting
If, after slide-out assembly and slide-out room installation is complete, slide-out does not perform as
expected, make sure the battery is fully charged then for check the following:
• Slide rails and rack and pinion are free of dirt, debris or other types of contamination restricting travel.
• No visible signs of external damage to the motor, assembly or rails.
• The motor is wired properly and all connections are secure.
During troubleshooting, changing, altering or adjusting one component may affect another. Make sure any
changes do not create a new problem.
Slide-Out Concerns
During retracting of the slide-out, if the top or bottom of the room hits the opening before its opposite side
does, then the room is tilted and must be re-leveled. The drive-side and idler-side adjustment assemblies
(Figs. 3 and 4) may require an adjustment to one or both of the adjustment bolts.
1.
Use a 1 5/16" wrench to back out—loosen—the 7/8 - 14 UNF jam nut (Fig. 9A) a few threads.
2.
Use a 9/16" wrench on the adjustment bolt (Fig. 9B) to raise or lower the tilt angle of the slide-out until
the slide-out is level.
NOTE:
Check level of slide-out after each adjustment.
3.
After the slide-out has been leveled across the drive-side and idler-side, tighten the 7/8 - 14 UNF jam
nut (Fig. 9B) against each base's fixed stop nut (Fig. 9C).
4.
Do a final level-check on the slide-out before operating the slide-out for tilt adjustment verification.
Fig. 9
C
A
B