Rev: 11.27.19
Page 10
CCD-0002710
Operation
Make sure the unit's T-molding and interior (determined by OEM) are installed prior to operating the
slide-out. Make sure the battery is fully charged and hooked up to the electrical system.
Extending Slide-Out Room
1.
Press and hold the rocker switch in the OUT (Fig. 8A) position until the room is fully extended and
stops moving.
NOTE:
Only hold the switch's OUT position until the room stops.
2.
Release the switch, which will lock the room into position.
3.
Check hard stops for proper location and desired extension of the slide-out.
Retracting Slide-Out Room
1.
Press and hold the rocker switch in the IN position (Fig. 8B) until room is fully retracted and
stops moving.
NOTE:
Only hold the switch's IN position until the room stops.
2.
Release the switch, which will lock the room into position.
3.
Check hard stops for proper location and desired retraction of the slide-out.
Fig. 8
A
B
Hard Stops
Without hard stops, the interior trim and the outside slide flange become soft stops and can be damaged
since the slide controller or motor clutch will not be able to shut the system off.
The hard stop will allow the motor to clutch, or the control box to sense the amperage spike, when the slide
motor is stopped. The stops shut down the slide-out system, protecting the drive shaft, shaft bolt and the
crown gear.
Room extension adjustments are made by repositioning the stop blocks on both ends of the hat channel.
A
3/16
" hex wrench is used to set stop block positions. Go to Room Stop Adjustment section for instructions
on how to set hard stop locations to ensure proper slide-out seal-in and seal-out.