Lipper Oblo 1.0, Руководство по установке OEM

Страница: 3 / 6

Rev: 09.08.22
Page 3
CCD-0006415
• (6) #10 x 1/2" (3,5 x 13mm) screws
• Appropriate drive bits
• Cordless or electric drill or screw gun
• 1-2 people depending on task
Installation
1. Center the Oblo aluminum blind over the window (Fig. 1).
NOTE:
Oblo aluminum blinds have custom sizing. Blind sizes and images used in this document are for
reference only when assembling, installing and/or operating this product.
2. Verify that the blind is spaced evenly around the window by measuring at the top (Fig. 1A), bottom
(Fig. 1B), left side (Fig. 1C), and right side (Fig. 1D) between the window frame and the blind.
Measurements A and B should be equal and measurements C and D should be equal.
Fig. 1
Caps
Inside blind
Window edge
Wall
Fig. 2
3. Fasten the blind to the wall using the (6) #10 x 1/2" (3,5 x 13mm) screws.
NOTE: Be careful not to damage the internal cable when installing the mounting screws (Fig. 2).
4. Once secured, place the caps in the holes one by one.
Internal cable
A
D
C
B
Resources Required
Fastener holes (3)
Fastener holes (3)