![background image](http://html1.mh-extra.com/html/linn/lk260/lk260_service-manual_1925485007.webp)
LK2 Service Manual
Page7
Copyright © 2000 Linn Products Limited. All rights reserved.
Contents
Paul O'Neill
Step 3. Re-assemble the LK2
1. Re-attach the heatsink:
Apply heatsink compound in a single line along the centre of the coupling block as shown below
If board was attached to heatsink by nuts & bolts – follow the instructions below:
•
Remove all five bolts from the board and slide the bolts into the slots, arranged as shown below
•
Place the board onto the heatsink so that all the bolts pass through their respective holes on the
board (some readjustment is usually necessary).
•
Screw the nuts onto the bolts but do not tighten fully.
•
Adjust the position of the board with respect to the heatsink so that the two are matched up – i.e.
the two are parallel with each other and neither the board nor the heatsink are protruding at either
side (see pictures below – exaggerated to show problems clearly)
•
Once heatsink and board are matched up, tighten bolts.
If heatsink was attached with allen screws:
Heatsink
Slide the bolts into the
slots - positioned as
shown
Heatsink
protruding
from one side
Heatsink
not parallel
to board
Heatsink
compound
here
Содержание LK260
Страница 35: ......