Operating Instructions
for
REDGUM Amplifiers
Models
RGi35 - RGi60 - RGi120
Lost keys can be replaced. Information is kept on file at the
factory about every REDGUM amplifier manufactured. By
quoting the Serial No. (on the under side of your amplifier,
on the carton or on the Final Test Report) another key can
be provided.
Just Fax a request for a new key and your FINAL TEST
REPORT (noting any change of address) to:
REDGUM Australia - Fax+61 3 9897 1399.
A replacement key will be sent by Air Mail the same day.
*****
When turning the power ”on”, a slight ‘pop’ may be heard
from the speakers. This is normal and will not damage your
loudspeakers. After the power is turned “off”, the amplifier
will continue to operate until the reservoir capacitors are
exhausted. During this time period, odd sounds may be
heard - they also are normal and will not harm your
speakers.
*****
WARNING
DO NOT REMOVE THE COVER on your
REDGUM amplifier. There is the RISK of a FATAL
ELECTRIC SHOCK.
*****
The only fuse used is the mains fuse located outside the
cabinet in a small compartment of the IEC mains input
connector. This connector is found where the mains power
cord plugs in at the rear of the amplifier. To check for a
‘blown’ fuse, turn off the power at the wall socket and
remove the plug. Pull the power cord from the IEC socket
and locate the small drawer under the socket. Remove the
drawer by pulling straight out. Pull the fuse from the holder
and check the fine internal wire. If it is incomplete, replace
it with the spare fuse located in the body of the drawer.
The fuse is a SAFETY device. DO NOT experiment with
other sized fuses. Severe damage and/or a FATAL
electric shock could result. REDGUM fuse values are as
follows:
60watt amplifier used on 220-250v - 2 Amp
60watt amplifier used on 100-120v - 4 Amp
120Watt Amp. used on 220-250V - 4 Amp
120Watt Amp. used on 100-120V - 8 Amp
If in any doubt whatsoever - consult your dealer.
*****
Before returning your amplifier for repair service you
should try the following test. Disconnect all connectors
from inputs, Tape Out and speaker terminals. Connect a
pair of speakers (with attached leads) from another
Complete for Warranty Registration :
Name __________________________________________
Address ________________________________________
City ____________________________ Zip code________
Country ______________ Date of purchase__________
Place of purchase _______________________________
Model No._______________________________________
Serial No. (if any) ________________________________
Fax
this page to the REDGUM Audio factory at
+613 9897 1399
or Email details (incl. S.N.) to
<
>
