![background image](http://html1.mh-extra.com/html/linn/lk260/lk260_service-manual_1925485025.webp)
LK2 Reliability Modifications
Page8
Copyright © 2000 Linn Products Limited. All rights reserved.
Paul O’Neill
•
Once heatsink and board are matched up, tighten bolts.
If heatsink was attached with allen screws:
•
Slide the single nut/bolt (still attached to board) into the middle of its slot – do not tighten
•
Rest the board on the heatsink in a central position.
•
Line up the screw holes in the board with those in the heatsink and screw in all four screws – but
do not tighten fully.
•
Line up the board and heatsink so that they are parallel and level with each other (as diagrams
above) and then tighten the screws fully.
•
Tighten the nut/bolt
3. Refit boards into tray – just do the reverse of the dismantling process described at the start of this
document.
4. Refit sleeve
5. Test amp fully
Содержание LK260
Страница 35: ......