24
Chapter 5: Configuring the ADSL Gateway
The Security Tab
ADSL Gateway with 4-Port Switch
type of encryption that is being used by the VPN device at the other end of the tunnel. Or, you may choose not
to encrypt by selecting Disable. In the screen shown, DES (which is the default) has been selected.
•
Authentication. Authentication acts as another level of security. There are two types of authentication: MD5
and SHA (SHA being more secure). As with encryption, either of these may be selected, if the VPN device at
the other end of the tunnel is using the same type of authentication. Or, both ends of the tunnel may choose
to Disable authentication. In the screen shown, MD5 (the default) has been selected.
•
Key Management. Select
Auto (IKE)
or
Manual
from the drop-down menu. The two methods are described
below.
Auto (IKE)
Select
Auto (IKE)
and enter a series of numbers or letters in the Pre-shared Key field. Based on this word,
which MUST be entered at both ends of the tunnel if this method is used, a key is generated to scramble
(encrypt) the data being transmitted over the tunnel, where it is unscrambled (decrypted). You may use any
combination of up to 24 numbers or letters in this field. No special characters or spaces are allowed. In the
Key Lifetime field, you may select to have the key expire at the end of a time period. Enter the number of
seconds you’d like the key to be useful, or leave it blank for the key to last indefinitely. Check the box next to
PFS (Perfect Forward Secrecy) to ensure that the initial key exchange and IKE proposals are secure.
Manual
Select
Manual,
then select the Encryption Algorithm from the drop-down menu. Enter the Encryption Key in
the field (if you chose DES for your Encryption Algorithm, enter 16 hexadecimal characters, if you chose
3DES, enter 48 hexadecimal characters). Select the Authentication Algorithm from the drop-down menu.
Enter the Authentication Key in the field (if you chose MD5 for your Authentication Algorithm, enter 32
hexadecimal characters, if you chose SHA1, enter 40 hexadecimal characters). Enter the Inbound and
Outbound SPIs in the respective fields.
•
Status. The status of the connection is shown.
Click the
Connect
button to connect your VPN tunnel. Click the View Logs button to view logs. Click the
Advanced Setting
button and the Advanced IPSec VPN Tunnel Setup screen will appear.
When finished making your changes on this tab, click the
Save Settings
button to save these changes, or click
the
Cancel Changes
button to undo your changes.
Figure 5-15: VPN with Manual Key Management
