6
9. Making calls
9.1 Making direct calls to the pagers on one click
•Press HOLD, “DIRECT” should appear. At this
point, any one-digit number(0-9) pressed calls
that specifically registered pager.
•ex) Press 2 – “DIRECT 2” shows up and the
pager registered under ID: 2 would be called and
should display the default “---”.
•ex) Now press 6 – “DIRECT 6” appears without
having to delete the previous 2. The same thing
should happen as before.
9.2 Making direct calls from several transmitters
When a network consists of several transmitters, each
one sends its code to the pagers when making direct
calls (max 8 transmitters per network identified by the
preset codes K1,K2,K3, K4,K5,K6,K7,K8). So when a
direct call is made, the pager will display the transmitter
code number rather than the default; making it easier to
identify where the call comes from.
Furthermore, it’s possible to configure different modes
such as melody/vibration to the transmitters so that the
calls sent from each one notifies the target card pager
in different ways. (see section 12)
9.3 Making simultaneous calls to all pagers
•
Press the FUNC. button:
•
Press the CALL/ ALL CALL button:
The message sent will be the default (“---”)
9.4 Making calls with memorized message
When having to deal with sending the same message
several times, short messages of up to 5 letters can be
memorized on the transmitters (i.e: KITCN, RECPT,
CONTR[counter], PIZZA, CNTR1, CNTR2, etc).
Example:
•
Press
•
Press
•
Type the message (ex. RECPT)
•
Press
_
”
(If less than 5 letters)
•
Press HOLD
•
Press the ID number of the card pager to call.
•
Press CALL. The pager displays the
memorized message (ex. RECPT).
•
To call other pagers, press another ID number
of a pager and press CALL.
To discard the memorized message press AC:
AC