Linkcom LINK 2800 DECT, Руководство по эксплуатации

Страница: 23 / 27

19
Oper
ating instructions
4 Telephoning
4.1 Making external telephone calls
4.1.1 Incoming calls
When your telephone rings, lift the receiver and press the handset key
on your phone.
Incoming calls without direct dialling in
If the Direct Dialling In parameter is not activated (see parameter 21),
incoming calls are signalled on lines 1 and 2 according to the call
assignment for the handsets.
Incoming calls with active direct dialling in
Incoming calls are accepted by the LINK 2800 DECT/GAP. The caller
has the option of triggering a signal on the desired handset by post-
dialling the DTMF digits 1-8. If no direct dialling is detected within five
seconds, the signalling is carried out according to the call assignment.
Call waiting
If the Call Waiting parameter is activated, an incoming call generates a
call waiting signal in an existing call. Call waiting can be suppressed
using
#4
.
Accepting the waiting call and ending the existing call: After
replacing the receiver, the phone will ring again and the waiting call can
be accepted.
Accepting the waiting call and holding or retrieving the
existing call:
The current caller is put on hold using
**0
or the INT
key and the waiting call is accepted.
**0
can be used to toggle
between the devices.
Pick up
If another of the handsets rings,
#3
allows you to pick up this call.
Hold
To prevent the caller hearing conversations in the room during a call, the
caller can be put on hold using
**0
. The call is also retrieved by
pressing
**0
.
Internal enquiry calls
During an external call,
**
+ handset number can be used to hold an
internal call while the first call is put on hold.
**0
is used to retrieve
the external call.
4 Telephoning
18
3 Programming mode
3.3 Overview: Telephone numbers and codes
#9 Activate programming mode
- 11 Call assignment
- 12 Line assignment
- 13 Authorisations
- 14 Fax subscribers
- 15 Deregistering a handset
- 16 Connection pick-up (SBCT)
- 21 Direct dialling in
- 22 Call waiting
- 23 Flash time
- 24 CLIP
- 26 PIN change
- 27 MOH
- 40 Blacklist
- 43 International/national authorisation
- 45 Provider setting
- 46 Provider selection
- 51 Parameter query
- 90 Reset parameters
- 91 Reset LINK 2800 DECT/GAP
**1 Call to handset 1 (functions as “INT key”)
**2 to **8 also for handsets 2-8
**9 Hunt group call to all registered handsets
**0 Activate hold (or INT key)
#1 Seize line 1
#2 Seize line 2
#3 Pick up
#4 Reject call waiting
#60 Switch off provider selection
#61 Switch on provider selection