Linhai ATV 500-D T3 EFI, Руководство по обслуживанию

Страница: 224 / 291

CHAPTER 5 FINAL DRIVE
LH500ATV-D T3 EFI SERVICE MANUAL 19.0
CHAPTER 5 FINAL DRIVE. 5- 20
8. Mount the axle sleeve U of the inner & outer
race in the neck of the bevel gear-driving V.
→Fig 8
Fig 8
9. Mount the bearing W into the suited hole of
the bevel gear bearing housing Z.
Mount the bearing retainer X in the bevel
gear bearing housing Z with the special tool
，
tight securely (90~100N.m) .
Mount the O-ring a into the groove of the
ring gear bearing housing Z.
Mount the oil seal Y into the suited hole of the
bevel gear bearing housing Z.
→Fig 9
Fig 9
10. Mount the adjust shim b in the shaft neck of
the bevel gear-driving V.
Mount the bevel gear-driving V into the hole
of the bearing W.
→Fig 10
Fig 10
11. Mount the adjust shim d in the shaft neck of
the bevel gear bearing housing Z.
Make the rear gear case G and the bevel
gear bearing housing Z together .
→Fig 11
Fig 11
12. Apply some Loctite 242 threadlocker on
screw thread
.
Tighten the four bolts M8×35 e to a torque
of 20~25N.m .
→Fig 12
Fig 12