Linhai ATV 500-D T3 EFI, Руководство по обслуживанию

Страница: 213 / 291

CHAPTER 5 FINAL DRIVE
LH500ATV-D T3 EFI SERVICE MANUAL 19.0
CHAPTER 5 FINAL DRIVE. 5- 9
axle and discard the boot band
“
A
”
,
it cannot be reused.
9. Inspect the drive axle as described in this
chapter.
INNER CV JOINT INSPECTION
1. Clean the bearing assembly in solvent
and thoroughly dry.
2. Inspect the steel balls, bearing case and
the bearing race for wear or damage.
3. Check for wear or damage to the inner
splines of the bearing race.
4. If necessary, disassembly the bearing
assembly for further inspection. Carefully
remove the steel balls from the bearing
cage then remove the bearing race from
the bearing cage.
5. If any of the components of the bearing
assembly are damaged, replace the entire
assembly as no replacement parts are
available.
6. Clean the inner CV joint in solvent and
thoroughly dry.
7. Inspect the interior of the inboard joint
where the steel balls ride. Check for wear
or damage and replace the joint if
necessary.
8. Inspect the snap ring groove on the
inboard joint for wear or damage.
9. Inspect the splines on the inner CV joint
for wear or damage.
10. Check the stopper ring in the end of the
inboard joint. Make sure it seats in the
groove correctly, if damage the ring must
be replaced.
11. Inspect the exterior of the inner CV joint
for cracks or damage, replace if
necessary. Check the movement of the
joint for excessive play or noise by moving
the drive axle in a circular and reciprocate
direction.
12. Inspect the drive axle for bending, wear or
damage.
13. Inspect the inner end splines, the outer
end splines and the front hub cotter pin
Check the movement of the joint