Linhai ATV 500-D T3 EFI, Руководство по обслуживанию

Страница: 209 / 291

CHAPTER 5 FINAL DRIVE
LH500ATV-D T3 EFI SERVICE MANUAL 19.0
CHAPTER 5 FINAL DRIVE. 5- 5
torque.
5.4 FRONT HUB BEARING REPLACEMENT 4X4 (ATV500)
1. Remove outer snap ring.
2. Form the back side, tap on the outer
bearing race with a drift punch in the relief
as shown.
3. Drive bearing out evenly by tapping on
outer race only. Once bearing is at bottom
of casting, support casting on outer edges
so bearing can be removed.
4. Inspect bearing.
NOTE:
Due to extremely close tolerances
and minimal wear, the bearings must be
inspected visually, and by feel. inspect for
rough spots, discoloration, The bearings
should turn smoothly and quietly, no
detectable up and down movement and
minimal movement sideways between inner
and outer race.
5. Inspect bearing housing for scratches,
wear or damage. Replace housing if
damaged.