Lingenfelter NCC-001, Инструкция по установке и эксплуатации

Страница: 146 / 171

Lingenfelter NCC-001 Nitrous Control Center Installation and Operating Instructions 145
Center software. When the you flash a new user program to the controller, the new program will erase the original
program and load the new program onto the controller. The only way to retrieve and reuse the program is if the
program was backed up on the computer.
Access from the Computer Program:
There are three (3) ways to save a User Program File to the controller, denoted below by the bullet points.
Press Ctrl+Alt+S
From the
Status screen , click on the File button in the upper left-hand corner of the window, then click on the
"Save User Program to Controller" button.
From the Status screen , click on the "Save User Program to Controller" button in the toolbar on the upper left-
hand side of the window, as shown below.
Once the "Save User Program to Controller" button has been pressed, a status window will appear showing the
status of the upload, as shown in the illustration below. Once the status window disappears, the flashing of the
user program is complete and the flashed user program replaces the current program on the controller.
8.2 Managing Data Logs on the Controller and Computer
The following options allow the user to manage and view the data logs that are saved on the computer, as well as
the data log saved into memory on the NCC-001 controller.
Warning: A new data log can not be created until the existing log is erased. The memory in the NCC-001