Lingenfelter NCC-001, Инструкция по установке и эксплуатации

Страница: 119 / 171

Setup Menu 118
change will be made.
Access from the Computer Program:
From the Status screen , select the relay by pressing either the "Relay1" button or the "Relay2" button. The
"Nitrous PSI Enable" option is located in the "Relay Control Options" dialog box. Check the box to enable the
Nitrous Pressure Control Option or un-check the box to disable the option.
7.10 PWM Out Menu
This menu is not currently functional, but will be used in future software builds.
Access from the Controller:
From the Main screen , press the “SETUP” button. Press the “DOWN” arrow button repeatedly until the "PWM
Out Menu" selection is highlighted and then press the “ENTER” button. This menu is not currently functional, so
press "OK" to exit.
7.11 Hall Input Menu
The following options are found in the Hall Input Menu, which can be accessed by the "SETUP" button on the
main screen or by clicking Hall Input tab in the Setup menu of the computer software. Currently, this input can
only be used for vehicle speed signal input.
MPH Option
This option enables the input settings used to configure the Hall Input to monitor vehicle speed. The input signal
needs to be a square wave signal or connected to the output of an open drain hall effect sensor. The Pulse Per
Mile setting in the ECM must be configured properly for an accurate reading.
The Hall Input has a programmable Pull-Up resistor for use in applications that require a Pull-Up resistor, but do
not already have one in the circuit.