LineEye LE-2500XR, Инструкция по эксплуатации

Страница: 78 / 140

-76-
CALL Command (Subroutine Call Command))
The CALL command is used to call a subroutine.
CALL L□□□
<Entering>
Cursor Position Enter & Operation
Command Field 5
Sub-Command Field -
Operand Field Enter the label number in three digits decimal figures with the key, [0] to [9].
<Operation>
・
The program control branches to the subroutine that is marked with the label number specified in the oper -
and field. The subroutine can be nested up to 100 folds.
6 ) IF REG□ □ REG□ L□□□ (Judgment Command on Register Value)
<Entering>
Cursor Position Enter & Operation
Command Field 4
Sub-Command Field 5
Operand Field
Enter a register number with the key, [0] to [F].
Input the inequality by 0 : = , 1 : ≠, 2:<, 3:> , 4:≤, 5:≥.
Enter the label number in three digits decimal figures with the key, [0] to [9].
<Operation>
・
The program control branches to the designated label, if the inequality relation between registers of operand
filed is satisfied.
If you want to compare the contents of a register with a constant value, execute this command after setting the con-
stant value in another register by using the SET command.
7 ) IF TBL□□ L□□□ (Judgment Command on Data Table Comparison)
<Entering>
Cursor Position Enter & Operation
Command Field 4
Sub-Command Field 6
Operand Field
Operand Field: Specify the table group in the 1st digit, and the table No. in the 2nd
digit with 00~9F.
Enter the label number in three digits decimal figures with the key, [0] to [9].
<Operation>
・
The program control branches to the designated label number if data satisfied up to 23 characters from the
top of data, which is registered in the specified data table in the operand field, is detected in the frame buffer
by the WAIT FRM command.
・
Parity bit is not a object to be compared.
4.1 Register Transmission Data
8 ) IF DA □□+REG□ L□□□ (Judgment Command on Data Array Comparison)
<Entering>
Cursor Position Enter & Operation
Command Field 4
Sub-Command Field 7
Operand Field
Operand Field: Specify the data array No. with the key, 0 to 9.
Enter a data array number with the key, [0] to [F].
[END/X]: * (Don’t Care) allows the offset to be invalid.
Enter the label number in three digits decimal figures with the key, [0] to [9].
<Operation>
・
The program control branches to the designated label number if data, satisfied with data being set in the
specified data array in the operand field, is detected in the frame buffer.
・
The method of designating a data array number is the same as that of “SEND DA Command.”