LineEye LE-2500XR, Инструкция по эксплуатации

Страница: 60 / 140

-58-
Operation
Press [RUN] to start the flow control test.
〇
“Send test” with X-ON/X-OFF flow control
1) When the analyzer is DTE mode, RTS and DTR will become active. When the analyzer is DCE mode, CTS,
DSR an DCD become active.
2) If the initial state is “ON”, it will start the data transmission immediately. If the initial state is “OFF”, it will
start the transmission after receiving the X-ON character.
3) Transmission is interrupted when it receives X-OFF character. And transmission is re-started when it receives
X-ON character.
〇
“Send test” with handshake flow control
1) When the analyzer is DTE mode, RTS and DTR will become active. When the analyzer is DCE mode, CTS,
DSR an DCD become active.
2) Transmit selected data table repeatedly while the selected control line at “Watch/Operate line” is active.
Transmission is interrupted when the selected control line is non-active. When the analyzer is DTE mode,
CTS (or DCD) set at “Watch/Operate line” is used. When the analyzer is DCE mode, RTS (or DTR) set at
“Watch/Operate line” is used.
ڦ
X-ON/X-OFF code
Set X-ON/X-OFF character in HEX. Normally, you do not have to change the initial value.
ڦ
Watch/Operate line
Set a pair of control line to allow transmission and request transmission. A pair of RTS and CTS is
mostly used.
ڦ
Table group (for “Send test”)
Select a group of transmission data table.
ڦ
Tx-table (for “Send test”)
Select a transmission data table.
ڦ
Idle time (for “Send test”)
Select the idle time. (0 to 9999ms)
ڦ
ON count (for “Receive test”)
The number of a reception character until interruption request is transmitted. (1~999999)
ڦ
OFF time (for “Receive test”)
Time between interruption request and re-transmission request. (0 to 9999ms)
ڦ
Initial state
Initial state of flow control at the begging of test.
OFF : Prohibit transmission
ON : Allow transmission
ڦ
Control method
Select the control method.
Character : X-ON/X-OFF character
Line : Handshake of control line