Linear ADT Pulse GD00Z-2, Руководство по установке

Страница: 14 / 16

12
Operation Notes
Indications and Operation Notes
◆
The warning light will fl ash and the warning beeper will sound for fi ve seconds before the
door opener is activated.
STAY CLEAR OF THE DOOR, AND DOOR OPENER. THEY ARE
ABOUT TO MOVE!
◆
If the door does not completely open or close after remote activation, the Controller
will allow user to try to operate the door one more time. If the second attempt fails, the
Controller will go into lock-out mode. See next paragraph.
◆
If the GD00Z-2 is in lock-out mode and will not accept remote commands, activate the door
from the pushbutton wall console.
◆
Once the Controller has initiated the movement of the garage door, another command cannot
be sent for 30 seconds. This eliminates the chance of “bouncing” the garage door and
possibly damaging the garage door opener.
Tilt Sensor Battery Replacement
When The Tilt Sensor Battery Gets Low
The system will notify you when the Tilt Sensor battery gets low and needs replacing.
1. Use a small screwdriver to open the Tilt Sensor case.
2. Remove the low battery and insert a fresh Type CR2032 coin cell battery. BE SURE THE
PLUS SIDE IS UP .
✓
IMPORTANT! Disposal of used batteries must be made in accordance with the waste
recovery and recycling regulations in your area.
3. Return the Tilt Sensor to the garage door top panel and snap it onto the mounting plate.
BE SURE THE ARROW ON THE SIDE OF THE TILT SENSOR IS POINTING UP.
CR2032
PLUS SIDE UP !!
!
SLOT
1
2
3
"UP"
ARROWS
SNAP SENSOR ONTO
THE MOUNTING PLATE
THE SYSTEM WILL NOTIFY YOU
WHEN THE BATTERY IS LOW,
REPLACE THE BATTERY WITH
A TYPE CR2032 COIN CELL
TO OPEN THE CASE, TWIST
A SMALL SCREWDRIVE IN
CASE SLOT
INSERT THE FRESH
BATTERY INTO THE
TRANSMITTER
SNAP THE TILT SENSOR ONTO
THE MOUNTING PLATE BEING
SURE THAT THE ARROW ON THE
SIDE IS POINTING UP
Figure 8. Replacing the Tilt Sensor Battery