LINDY CPU Switch Multiscreen Installation and Use
Page 15
To enter configure mode at power on:
Switch off all the attached PCs and the LINDY CPU Switch Multiscreen. Hold down
the front panel key whilst powering on the LINDY CPU Switch Multiscreen.
Remember that the LINDY CPU Switch Multiscreen draws its power from any
attached PC via the keyboard cable and so will power itself on when the attached
PC is switched on or when the optional power adapter is connected. Do not release
the key until the LINDY CPU Switch Multiscreen displays ’C’ to show that it has
entered configure mode.
To enter configure mode whilst the LINDY CPU Switch Multiscreen is running:
Hold down the front panel key for 5 seconds until the front panel display shows ‘C’.
In configure mode, options are entered by typing a letter followed by a number
followed by (return). Use ESC to abort the entry of an option. The LINDY CPU
Switch Multiscreen will remain in configure mode until you type 'E' (return).
For example: to set hotkey option 2 type the following at the 'C' prompt
(at LINDY CPU Switch Multiscreen 'C' prompt)
+I
To exit configure mode type:
(I
2.7 Summary of LINDY CPU Switch Multiscreen configuration
options
Full details of each of the configuration options and their uses are given in section 4.
B1 - screen saver disabled (default)
B2 - Blank screen after 1 minute of inactivity
B3 - Blank screen after 2 minutes of inactivity
B4 - Blank screen after 4 minutes of inactivity
B5 - Blank screen after 8 minutes of inactivity
B6 - Blank screen after 12 minutes of inactivity
B7 - Blank screen after 16 minutes of inactivity
B8 - Blank screen after 20 minutes of inactivity
