12
13. CONNECTION AND REGULATION OF KONTAKT 155/R WITH CO
2
PRESSURE
BOTTLE
1.
Screw speed
fi
ttings onto the keg coupler.
2.
Plug 3/8" and 5/16" hoses into the speed
fi
ttings on the keg coupler.
3.
Connect the 3/8" and 5/16" hose with the speed
fi
ttings located on the cooler in accord-
ance with the description found on the label above the speed
fi
ttings.
4.
Screw the high pressure hose onto the CO
2
bottle using a
fl
are nut.
5.
Fit the keg couplers onto the beverage keg, but leave the keg coupler in closed position
(top position).
6.
Open the valve on the CO
2
bottle and use the regulating screws on the top of the cooler to
set the desired pressure for both the separate beverage lines. (The set pressure is displayed
on the pressure gauges located on the front of the cooler).
7.
Tap the keg using the keg coupler.
WARNING:
Check that all joints are su
ffi
ciently leak-tight after connection.
If everything is in order, check the thermostat settings (in o
ff
position). Connect the cooler to the
power mains. Then use the keg coupler to tap the keg, set the desired pressure (1.0-3.4 bar) and
use the tap lever to pour out some of the beverage. If the cooler contains remnants of sanitation
solution or water, keep the tap lever in open position until only beverage pours out of the tap.
Set the desired beverage temperature on the thermostat.
14. HOW TO WORK WITH SPEED FITTINGS
14.1 Speed Fitting Installation
Grasp the speed
fi
tting and insert the hose all
the way inside the speed
fi
tting body (ca. 20
mm). The end of the hose must be straight so
that it plugs fully into the coupling. If the hose
will not go in, moisten the end of the hose.
fi
gure
12 b
