AUTOLAMPS
The autolamp system provides light
sensitive automatic on/off control of
the exterior lights normally
controlled by the headlamp control.
The autolamp system also keeps
the lights on for approximately
20 seconds or, if equipped with a
message center, you can select a
delay from 0–180 seconds after the
ignition switch is turned off. See
Message center
in the
Instrument
Cluster
chapter.
•
To turn autolamps on, rotate the control counterclockwise one
position.
•
To turn autolamps off, rotate the control to the off position.
INSTRUMENT LIGHTING DIMMER
Use to adjust the brightness of the
instrument panel when exterior
lights are on.
•
Rotate the control from left to
right to brighten the instrument
panel.
•
Rotate the control from right to
left to dim the instrument panel.
•
Rotate the control fully to the right (past detent) to turn on interior
lamps.
•
Rotate the control to the left position (past detent) to turn off the
interior lamps and to disable the illuminated entry feature. When the
control is in the far left position, it acts as a dome lamp
defeat/override.
Note:
If the battery is disconnected, discharged, or a new battery is
installed, the instrument lighting dimmer requires re-calibration. Rotate
the control from the full dim position to the full dome/on position to
reset. This will ensure that your displays are visible under all lighting
conditions.
90
Lighting
2014 Navigator
(nav)
Owners Guide gf, 1st Printing, June 2013
USA
(fus)
