Lincoln Electric SA-400I, Руководство оператора

Страница: 11 / 68

A-3
INSTALLATION SA-400I
®
Welder Enclosure
- The complete welder is rubber mounted on
a rugged steel “C” channel base.
The output terminals are placed at the side of the machines so
that they are protected by the door. The output terminals are
labeled (+) and (-).
Cranking System
- A 12 volt electric starter is standard.
Air Cleaner
- Heavy duty two stage dry type.
Muffler
- A muffler and stainless steel exhaust outlet elbow are
standard.
Fuel / Hour / LED gauge
- A meter to record hours of
operation, show fuel status, battery charging fault LED and
engine fault LED.
Engine Protection -
The system shuts the engine down in the
event of sudden low oil pressure or high coolant temperature.
A warning light on the control panel will indicate such a fault.
To reset the engine for restarting, turn the ignition switch off
then on. Refer to Troubleshooting section for all warning light
fault codes.
Battery Charging Light
- A warning indicator light for Low/No
battery charge. The light is off when the systems are functioning
properly. The light will come on if there is a Low/No battery
condition but the machine will continue to run.
NOTE
: The light will come on when the Run/Stop switch is in the
“ON” position. It will come on during cranking and stay on until
the engine starts. After, starting the engine the light will go off
unless a Low/No battery condition exists.
Oil Drain Valve -
A ball valve, hose and clamp are standard.
Remote Control
- The Remote / Local Switch and Receptacle
are standard.
PRE-OPERATION INSTALLATION
EXHAUST SPARK ARRESTER
Some federal, state or local laws may require that engines be
equipped with exhaust spark arresters when they are operated in
certain locations where unarrested sparks may present a fire
hazard. The standard muffler included with this welder does not
qualify as a spark arrester. When required by local regulations,
a suitable spark arrester must be installed and properly
maintained.
Use of an incorrect arrester may lead to engine damage or
performance loss. Contact the engine manufacturer for
specific recommendations.
LOCATION / VENTILATION
Always operate the welder with the doors closed. Leaving the
doors open changes the designed air flow and may cause
overheating.
The welder should be located to provide an unrestricted flow of
clean, cool air. Also, locate the welder so that engine exhaust
fumes are properly vented to an outside area.
This equipment is for industrial use only and it is not intended for
use in residential locations where the electrical power is
provided by the public low-voltage supply system. There can be
potential difficulties in residential locations due to conducted as
well as radiated radio-frequency disturbances. The EMC or RF
classification of this equipment is Class A.
Do not attempt to use this equipment until you have
thoroughly read the engine manufacturer’s manual supplied
with your welder. It includes important safety precautions,
detailed engine starting, operating and maintenance
instructions, and parts lists.
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts or elec-
trode with skin or wet clothing.
• Insulate yourself from work and ground
• Always wear dry insulating gloves.
ENGINE EXHAUST can kill.
• Use in open, well ventilated areas or vent
exhaust outside.
MOVING PARTS can injure.
• Do not operate with doors open
or guards off.
• Stop engine before servicing.
• Keep away from moving parts.
See additional warning information at the front of
this operator’s manual.
WARNING
CAUTION