Lincoln Electric K2803, Руководство оператора

Страница: 20 / 34

English English 17
MAXsa™ 19 SYSTEM CHECKLIST
 Place the Power Wave
®
AC/DC 1000 SD CE in a suitable operating location.
 DeviceNet PLC controlled systems: Mount DeviceNet PLC controller and User Interface.

Mount MAXsa™ 19 in it’s operating location.
 Connect K2683-xx Heavy Duty ArcLink Control Cables (5 pin) between Power Wave
®
AC/DC 1000 SD CE and
MAXsa™ 19.
 Connect K1785-xx Wire Feeder Control Cable (14 pin) between the MAXsa™ 19 and the MAXsa™ 29.
 DeviceNet PLC controlled systems: Connect each Arc Master power source to the PLC via the DeviceNet network.
 Install Work Voltage Sense Lead (21) from Power Wave
®
AC/DC 1000 SD CE per recomennded guidelines.
 Connect / Install welding cables per recommended "Output Cable Guidelines" (Table 1).

Open the Power Wave
®
AC/DC 1000 SD CE front panels and configure DIP switch settings per the decal on the
panel. Factory setting is “Master-Lead”.(See Figure #2).
 Connect input power to Power Wave
®
AC/DC 1000 SD CE per recommended guidelines.

Turn on Power Wave
®
AC/DC 1000 SD and verify all system Status Lights are solid green.
 DeviceNet PLC controlled systems: Run Weld Manager. For each Arc Master connect to the power source. Under
Network Settings -> DeviceNet-> Configuration, configure the DeviceNet MAC address and baud rate.
 Run Weld Manager. For each Arc Master connect to the power source. Under Feeder Settings -> Wire Feeder,
verify the appropri- ate Feeder and gear ratio are selected.
 Confirm that latest software is updated in all equipment prior to installation (www.powerwavesoftware.com)
 Select a Welding process and configure starting and ending options.