Lincoln Electric FLEXCUT 125 CE, Инструкция по технике безопасности, эксплуатации и обслуживанию

Страница: 28 / 44

8695 4496 / B
E-24
FLEXCUT 125 CE INSTALLATION
E - OPERATOR MANUAL
1 - OPERATOR CONTROLS
1.1 UI CONTROLS
All the user interface controls are available in the documentation 8695 4944, in the sections relating to
Flexcut 125
CE
installation
1.2 TORCH MOVEMENT CONTROLS
At any time (except if there is a fault or if the torch is not selected), the height of each torch can be modified in slow
speed. To do so, use the buttons in UI. (available in documentation 8695 4944, in the sections relating to the
Flexcut 125 CE
system).
2 - ADJUSTMENTS
2.1 PROCESS PARAMETER ADJUSTMENT
Process parameters can be adjusted from the UI. See the documentation 8695 4944, in the sections relating to
Flexcut 125 CE
installation
The part program particularities (size and location of striking, cutting quality etc.) also influence cutting quality. The
post-processor must comply with the recommendations of Lincoln.
The gas pressure values are to be adjusted on the power source (See the documentation IM10375)
2.2 TOOL HOLDER HEIGHT
See specific documentation of tool holder
3 - GAS SUPPLY CHANGE
When the gas supply is changed (cylinder change, for example), we recommend the following:
- Shut the cylinder to change
- Carry out a gas test on the power source till the fault appears
- Press the emergency stop button
- Change the cylinder in accordance with the supplier's recommendations.
- Check that there is no dust or pollution
- Check that there is no leak after each cylinder change.