Lincat Opus 800 OG8115/OP, Инструкция для пользователя, по установке и обслуживанию

Страница: 17 / 20

IS 681 ECN 4301 Page 17 of 20

Isolate from the gas supply.

Connect the oil return pipe M into position L

Set the thermostat to the
“Off”
position with the orange dot at the top of the control
dial.

Ensure that the drain bucket is firmly positioned within the fryer.

Operate the drain valve lever and drain the oil into the drain bucket.

Fully close the drain valve.

Select the Filtration mode to operate oil return. Select fryer mode to stop the oil
return.
OIL CHANGE AND CLEANING OF THE FRYER
When disposing used oil allow the oil to cool to below 40
O
C. Wear protective
clothing, gloves and safety glasses.

Isolate from the gas supply.

Set the thermostat to th
e “Off” position with the orange dot at the top of the control
dial.

Operate the drain valve lever and drain the oil into the drain bucket.

Connect one end of the hose to position L and the other end to the oil return pipe M.

Operate the pump and discharge the oil to a suitable container.

Remove the stainless drain basket, filter bag and batter plate and place on a suitable
drip tray.

Remove the back plate by turning the screws A and lifting off.

Clean all items through the dishwasher.

Remove large partials using a suitable tool such as a chip shovel.

Use paper towel or similar to remove any small partials of debris.

Make sure the drain valve is closed and wash the interior of the fryer tank with a mild
detergent. Drain and discard.

Ensure all components are dry.

Replace all the components.

Check that the drain valve is fully closed.

Fill the fryer with new oil to the lower indicated level.