Lincat Opus 800 OG8115/OP, Инструкция для пользователя, по установке и обслуживанию

Страница: 10 / 20

IS 681 ECN 4301 Page 10 of 20
Disconnect from both the gas and electrical supply before proceeding with
any of the following instructions.
Use only genuine Lincat spares.
TEMPERATURE CONTROL

Remove the control knob.

Undo the control panel retaining screws.

Remove the screws that retain the temperature control/switch assembly to the
control panel.

Disconnect the cable from the rotary switch.

Pull the temperature control from the switch to separate then undo the lock nut.

Reassemble in reverse order.
SAFETY THERMOSTAT.

Drain the fryer tank.

Undo the control panel (see above).

Undo the gland assembly and withdraw the capillary and bulb.

Remove the drain valve handle

Undo the four screws retaining the switch panel.

Undo the nut holding the limit stat to the switch plate. Disconnect the wiring.

Reassemble in reverse order.
FLAME SENSOR, IGNITER ELECTRODE AND LEADS

Remove the drain valve handle

Undo the four screws holding the switch panel and support under the drain valve.

Pull off the electrode cap and disconnect from the PCB ( if replacing the lead ) and
unscrew the electrode.

Reassemble in reverse order ensuring that the earth wire is reconnected on the
ignitor electrode and always use a new gasket. Do not over tighten the screws.
COMPONENT REPLACEMENT