Linak Deskline BA001, Руководство пользователя

Страница: 13 / 24

Page 13 of 24
Charging BA001
The BA001 can be charged either via the DESKLINE Control Box CBD6S or via the Switch Mode Power Supply SMPS006 using
a DC cable with 2-poled minifit plug. LINAK offers various cables with straight plug which can be used (e.g. 0705894-200).
Actual capacity
Turn on the light for a few seconds by pressing the small black button below the LED light bars. The four LED light bars
indicate the actual capacity.
Capacity Lit up LED light bars
0 to 5 % None
5 to 25 % LED1
25 to 50 % LED1 and LED2
50 to 75 % LED1, LED2 and LED3
75 to 100 % LED1, LED2, LED3 and LED4
Notes:
• When the capacity is below 25 %, the audio alarm sounds once each time the BA001 is activated.
• The battery turns off to protect itself when the capacity is approx. 5 %. Below 5 % capacity, the audio alarm sounds once
each time the BA001 is activated. No LED light bars can be lit.
• During charging, the LED light bars indicate the actual capacity.
• When the charging is complete the LED light bars turn off.
• Charging will not start if the capacity is above 75 %.
• The BA001 has a built-in protection to ensure battery and system lifetime.
• The battery limits the discharge current to approx. 10 A.
• The battery can go into a protected mode. Then a reset is made only after disconnecting the cable and in some cases
charging the battery
The BA001 switches off
In overload situations, the LED light bars will still turn on when the button is pressed. However, if the capacity is below approx.
25 % it is not possible to identify if the BA001 has switched off due to overload or low capacity.
If the battery is sufficiently charged and still switches off, it is due to an overload situation.
Solution: Reset the battery
1. Disconnect cable from BA001.
2. Press button on BA001 for minimum 10 seconds to reset battery.
3. If no LED light bars turn on, charge battery.
4. Connect BA001 again.
Charging via CBD6S:
In a DESKLINE system, the BA001 is connected to the CBD6S. Preferably, charge the battery while it is mounted on the
application.
1. Connect mains cable to CBD6S.
2. Plug cable into mains.
When the charging starts, the BA001 beeps twice. After approximately five hours (at room temperature, ≈ 20 °C), the BA001
is fully charged and the LED light bars turn off.
Transportation by plane is not allowed for batteries that are more than 30 % charged.