User Manual
18
Chapter 6-5-1. Alarm Input Type
The DVRs’ alarm inputs can be configured as normal open (N/O) or normal close (N/C).
The alarm input is one-to-one mapped to a camera respectively. Note that the alarm is a dry
contact, DC24V 1A, input.
Chapter 6-5-2. Motion Enable
Motion Enable enables motion alarm activation, if the motion area has been set with proper
motion sensitivity. Press Left or Right button at Motion Enable menu item to change the
setting.
Chapter 6-5-3. Sensitivity
There are eight levels of sensitivity adjustable for motion alarm triggering, range from Very
High to Very Low. Press Left or Right button to change the sensitivity setting.
Chapter 6-5-4. Motion Area Set
There are few ways to setup motion area. The detail setup sequence is described as follows:
Keypad
Remote controller
Mouse
Step 1
Enter Motion Area Set menu item.
Step 2
Press Menu button again for motion setup selection.
Right mouse click.
Step 3
Select “Motion Set” to define motion area(s)
Select a menu item using the
mouse.
Step 4
Press Up, Down, Left, or Right to move cursor
(cursor mode).
Move mouse for starting
position.
Step 5
Press ENTER button to start area selection
Step 6
Press Up, Down, Left, or Right for an area
Mouse drag for an area
Step 7
Press ENTER for cursor (cursor mode) and go to
step 4 for second area. To exit the menu, please
press Exit menu item/ Menu button.
Go to step 4 for second area.
Selection Exit menu item to save
changes and exit setup menu.
A user can also set or clear entire motion area by selecting Set All or Clear All menu item.
Chapter 6-5-5. Motion Tracer
Motion tracer can be used to determine the motion sensitivity. When motion tracer is set to
on, the motion grids are shown in red to represent motion triggers.
