6
Sabina
™
II sit-to-stand lift • 7EN155106 Rev 1
www.hill-rom.com I www.liko.com
Assembly
2. With the lift mast, the lifting height may be adjusted to three different
levels. Choose one of the three holes depending on the height of the
patient; the distance between holes is 5 cm/2 inch. (see illustration above).
Secure the lift mast in the base with the included locking handle.
1. Remove the locking handle from
the base. Place the lift mast in the
foot of the base.
3. A) Remove the locking handle from the lift
arm.
Slide the sling bar onto the lift arm
with the opening on the lifting hooks
facing upward (see illustration).
B) Attach the locking handle and tighten.
4. Place the battery in the control
box. Make sure that the battery
is secured (a click will be heard).
• Lift mast with lift arm, control box, lift motor
• Sling bar with safety latches and locking handles
• Hand control with cable
• Battery incl. holder for the charging cable
• Base incl. motor for base-width adjustment and locking
handles
•
Foot rest and frame for the foot rest
•
Lower leg support
• Bag containing instruction guide, charger connector
cable, and extension cord.
Before assembly, make sure you have the following parts:
NOTE! The sling bar is supplied separately, either as SlingBar 350 or the Comfort SlingBar. We show the Sabina sit-to-stand
lift with Comfort SlingBar in this description.
Individual adjustment of lifting height
Height of patient
Position
< 170 cm / 67 inch.
1
160-190 cm / 63-74.8 inch.
2
> 180 cm / 70.9 inch.
3
5. Connect the cables as follows:
- 1. cable, lift motor.
- 2. cable, motor for base-width
adjustment.
- H. cable, hand control.
H
A
B
7. Install the holder for the charging cable:
Hook it on the front edge of the battery
and push down on the back until you hear a
clicking sound.
A
C
B
6. A) Connect the charger cable to the socket under the control box.
B) Attach the connector cable to the strain relief system.
C) Plug the charger cable into the connector cable.