15
Sabina
™
II sit-to-stand lift • 7EN155106 Rev 1
www.hill-rom.com I www.liko.com
3. Advance the lift. Connect the sling’s suspension loops to
the sling bar’s hooks.
The height setting of the lift mast
may have to be adjusted, see page 6.
Before the patient is lifted from the underlying
surface, but after the sling’s straps have been fully
extended, make sure the straps are properly connected
to the sling bar.
4. Raise the sling bar to the lowest height necessary to
perform the transfer.
Make sure that the lifting motion is not so high that
the patient gets too close to the lift mast!
NOTE!
Lifting seated persons with Sabina sit-to-stand lift cannot replace lifting procedures for sitting persons using traditional
mobile lifts, e.g. using Viking
™
mobile lift, Uno
™
mobile lift, Golvo
™
mobile lift, or LikoLight
™
mobile lift. The function
is intended as a temporary solution when the patient cannot manage an active raising motion using Sabina sit-to-stand
lift. If the need for passive lifting persists, we recommend that you switch to one of the lifts mentioned above.
