Page 72 / 129
Section
6
.
Web
control
– Using built-in website
6.3.10. Output parameter settings
By clicking on an output label a dialog window appears showing the parameters for the
corresponding output.
Scope of changes
There are two options to apply changes. To set the scope of the changed settings, select
the desired option in the top left box.
Apply changes to current output:
this option means the modified parameters are applied
only to the currently selected port.
Apply changes to all outputs:
this option means that the modified parameters are applied
to all output ports.
Info:
When opening this window again, the scope selection will be set to “Current Output”
regardless of the active selection at the time of closing. It is to avoid making changes to all
outputs by mistake.
Reload factory defaults
Current output:
Reloads the default values to the currently selected output.
All outputs:
Loads the factory default values to all outputs.
Output properties
Mode
The ‘Mode’ can be set to Auto, DVI, HDMI 24bit, HDMI 30bit or HDMI 36bit. The ‘Auto’
option sets the signal mode regarding to the attached display device’s EDID and the
incoming signal.
HDCP
The ‘HDCP’ option sets the HDCP encryption on the output. The Auto setting applies
encryption when the incoming signal is encrypted. The Always setting forces encryption on
any video signal.
Signal status
Information about the signal and the connection status is shown here.
