REMOTE REGISTRATION FOR FLEXMIKE
ADDING OR REPLACING A FLEXMIKE USING THE REMOTE
4.
Determine what number microphone you wish to
register 1 or 2:
1.
If replacing a Flexmike, make sure the malfunctioning unit is
powered off.
2.
Power on the new Flexmike. Both microphone 1 and 2 blue lights
should be blinking.
3.
Open the Flexmike battery compartment and pull
the battery out (leaving it plugged in) to reveal the
registration button.
•
If replacing a microphone, match the # of the bad microphone
•
If adding a microphone, the new microphone would be #2
5.
On the remote, in rapid succession, press:
6.
The center button on the remote will begin blinking and the #1 light on the Topcat will begin blinking.
7.
Using a paperclip, briefly press the registration button on the Flexmike. The 1 and 2 lights will be blinking alternately.
8.
After several seconds, the #1 light on the Topcat will turn solid and the Flexmike will have just one light blinking (1 or 2
depending on which microphone is being replaced) and then turn solid.
9.
The registration is complete. Press the center button on the remote and begin speaking into the Flexmike to verify
there is audio.
10. Place system ID number (located in back of Topcat User Manual) on the new Flexmike.
Vol
Vol
Mute
6
5
1
3
2
4
UP
DN
A
B
C
Volume
Down
Mute
#1 or #2
A
B
C
Vol
Vol
Mute
6
5
1
3
2
4
UP
DN
Blinking lights
Power On
Blinking lights
(NEW Flexmike)
Blinking lights
