Lightspeed 7100DX QUAD-RAK, Руководство пользователя

Страница: 15 / 27

Operating Instructions
LightSPEED
Connecting the Microphone: Connecting the Microphone: Connecting the Microphone: Connecting the Microphone: Connecting the Microphone: LightSPEED offers various types of microphones that can
be used with this system. To connect the microphone, simply insert the microphone
connector into the TA4F connector on top of the transmitter. To remove, press the black
button on the microphone connector and pull out.
Microphone Options Microphone Options
Microphone Options Microphone Options
Microphone Options
The BP-900 Transmitter can be used with either a lapel style microphone or a headset
microphone. Both plug into the top of the transmitter as shown.
Headset Microphone Headset Microphone
Headset Microphone Headset Microphone
Headset Microphone
Several varieties of headset microphones are
available
(pictured is the LightSPEED TK-
250). Simply connect the microphone cord
directly into the jack on top of the transmitter
and place the headset around the back of the
head.
For optimal sound, position the
microphone just beside
the mouth.
Lapel Microphone Lapel Microphone
Lapel Microphone Lapel Microphone
Lapel Microphone
Several varieties of lapel microphones are
available
(pictured is the LightSPEED LS-4).
Simply connect the microphone cord directly
into the jack on top of the transmitter and clip the
microphone to lapel or collar.
For optimal
sound, position the microphone as close to the
mouth as possible.
Mic IN
Wireless Transmitter
Belt-pack
Operating Instructions
LightSPEED
• Turn the transmitter ON by pressing and holding the Power button on the side
(approximately 2 seconds). The LCD display will appear.
• Open the plastic door by depressing the latches on each side.
• Use the “up” and “down” buttons to select a screen that shows the current channel.
• To change the channel press and hold the “SET” button until there is a blinking
cursor on the LCD display window
(approximately 3 seconds).
• Use the “Up” and “Down” buttons to set the channel to match the receiver.
• Press and hold the “SET” button again until the blinking cursor disappears
(approximately 3 seconds).
T TT
TTransmission Frequency in MHz:
ransmission Frequency in MHz:
ransmission Frequency in MHz: ransmission Frequency in MHz:
ransmission Frequency in MHz: Press the “UP”
button once to view the transmission frequency in
MHz of the currently selected channel.
Wireless Transmitter
Belt-pack
Toggle
DOWN
Toggle
UP
Set
LightSPEED
Mute
Button
Red LED
Door
Latch
LCD
Display
ON/OFF
Switch
Setup Screens selectable with
the UP and DOWN Arrow Buttons
CH: 001
CH: 001
720. 250M
LS
BP-900
NiMH
AKLN
Channel Selection – Belt-pack T Channel Selection – Belt-pack T
Channel Selection – Belt-pack T Channel Selection – Belt-pack T Channel Selection – Belt-pack Transmitter
ransmitter
ransmitter ransmitter ransmitter
Once a channel has been selected on the receiver, you now need to select that same
channel on the belt pack transmitter.
13
NOTE: Transmitters and receivers are available in 5 different frequency groups. Verify that the letter
code that blinks on the receiver (when powered ON) matches the letter code on the frequency sticker in
the battery compartment of the transmitter.
CH: 001
720.250M
14