Lightmed LightLas 532/670, Руководство оператора

Страница: 74 / 127

Multi-Wavelength Pattern Scanning System - LightLas 532 / 670 – Operators Manual Rev. No 01
Page 73 of 126
B. LDU Systems / LCD System / Footswitch / Accessories
Three types of LDU system Lightmed manufacturing are:

Slit lamp (CSO980)

LIO (Optional)

Endoprobes (Optional)
Slit lamp Integrated LDU (CSO980)
Prior to install the Slit lamp Integrated system, ensure all the corrected setup and
equipment are in placed to proceed the installation steps.
System Part(s):

Upper Arm Housing

Lower Base Housing

Magnifier Housing integrated with zoom pc and Truscan

Binocular Ass’y

Accessories (cover, chinrest, and target rod)
Procedures:
1. Unpack all the packaging items from the cartoon box (refer to fig. 5.7)
2. Lay them over the fully assembled table ass’y and ensure the location is the final
destination and well level
3. Assemble the slit lamp upper arm and lower base housings together by fasten
the screw (refer to 5.8)
4. Carefully position the fully assembled slit lamp ass’y over the rail and gently slide
through the rails for the smoothness
5. Ensure the slit lamp ass’y is horizontally in parallel axis (realign if applicable) and
the cabling (slit lamp power / magnifier housing signal) out of way or not
jammed (refer to fig. 5.9)
6. Organize the cabling through the guide hole and strap Velcro tie underneath of
the table top (refer to fig. 5.10)
7. Plug in joystick cabling to the lower base housing (refer to fig. 5.9)
8. Place the gear cover ass'y
9. Glide the delivery housing with Truscan module integrated until it reaches to the
chrome stopper and gently secure the screw (refer to fig. 5.11a-b)