Lighthouse REMOTE 3104P, Руководство по эксплуатации

Страница: 48 / 82

Lighthouse REMOTE 3104P, 5104P Operating Manual
6-6 248083336-1 Rev 3
Note:
Typing commands
in the command console
requires a space between
the instruction and the
command variables. For
example, ’arp’ is followed
by a space, then ’-d’ and
another space, then the *.
Figure 6-2 Starting the Command Console
5. A command prompt window will open. Clear the ARP Cache by
typing
arp -d * at the command line and press Enter . Ignore any
error messages that indicate the address table doesn’t exist or has
no entries.
Figure 6-3 Clear Address Table Command
6. The next step requires the unit’s assigned IP and its MAC
address. The MAC address is a group of six two-digit characters
(0-9 and A-F) found on the back of the 3104P or 5104P that may
be referred to as the HW (Hard Ware) address.
7. The next step adds the IP and MAC addresses to the ARP Cache
which allows direct communications with the 3104P or 5104P
before an IP is programmed into its Ethernet interface.
8. Type arp –s xxx.xxx.xxx.xxx nn-nn-nn-nn-nn-nn and press Enter .
Replace the x’s with the desired IP address, such as 192.168.0.10
or 10.10.0.15, and the n’s with the 3104P or 5104P programmed
MAC address, such as 00-20-4a-8a-26-31. The IP address will be
four segments total with up to 3 digits per segment, each segment
separated by a period. Note that the MAC address segments are
separated by dashes (-), not periods.
Figure 6-4 ARP Command to Add New IP