Lighthouse Remote 3014PN, Руководство по эксплуатации

Страница: 27 / 84

Getting Started
248083317-1 Rev 4 3-5
8. Separate the wires and insert them into the loom based on the EIA/
TIA-568B standard. When all of the wires are in the correct holes,
push the loom onto the wires as far as it will go and verify that at
least one-half-inch of each wire extends beyond the edge of the
loom. This will allow for trimming the wires in a straight line
parallel to the loom edge. One-quarter-inch is required for
crimping into the RJ45 connector. Review the photos in Figure 3-4
to ensure accuracy.
Note:
The "pairing" of
wires in the loom changes
at positions 4 through 6.
9. Trim the ends of the wires in a straight line to one-quarter-inch as
illustrated in the center panel of Figure 3-4.
Figure 3-4 EIA/TIA-568B Color Code Example
10. Insert the wires and loom into the RJ45 connector (lock tab facing
down) and push inward until they fully butt against the end of the
wire channels as shown in Figure 3-5. The loom helps to keep the
wires positioned so they will go into the correct channel for
crimping.
Figure 3-5 Loomed Wires Being Inserted into RJ45
View is tab facing reader
View is from RJ45
opening
1/4-inch maximum
1/2-inch maximum