Lighthouse Remote 3014PN, Руководство по эксплуатации

Страница: 52 / 84

Lighthouse REMOTE-4PN Series Operating Manual
4-14 248083317-1 Rev 4
Cross-over Cat5/Cat6 Setup:
1. Attach one end of the cross-over cable to the RJ45 receptacle on
the PC.
2. Attach the other end of the cable to the REMOTE-4PN Data Port.
3. Apply power to the REMOTE-4PN. Apply power to the PC if it is
not already running. Observe the LEDs on the PC’s RJ45
connector - blinking indicates network/instrument activity.
Program the
Interface
Windows Telnet Programming:
This section is included just in case some of the automated programs
are not working and programming the instrument is not, yet, successful.
1. Start Windows.
2. On the Taskbar, click on Start .
WARNING:
Perform
only the steps or
commands as provided
in this guide. Failure to
heed this warning can
result in damage to
equipment, personal
injury or data loss and
may void the equipment
warranties.
3. Select Run as shown in Figure 4-9.
Figure 4-9 RUN Screen
4. In the Run window, type CMD and click OK. See Figure 4-10.
Note:
Typing commands
in the command console
requires a space between
the instruction and the
command variables. For
example, arp is followed by
a space, then -d and
another space then the *.
Figure 4-10 Starting the Command Console